Ikelite RC2 TTL Receiver for DS Strobes

Enjoy true TTL strobe exposure via fiber optic connection with your compatible Ikelite DS strobe.

With the RC2 TTL Receiver and a compatible camera with RC flash mode, actual exposure data is calibrated and communicated directly by the camera. This is far more accurate and consistent than "slave TTL" modes built into some underwater strobes which watch the camera's built-in flash and react.

An individual RC2 TTL Receiver and compatible fiber optic cord is needed for each strobe. Use of two strobes requires two receivers. See strobe and cable compatibility information below.

This product attaches to an Ikelite DS strobe. It is not intended to be attached to a housing and will provide no functionality if attached to a housing bulkhead. This receiver is not compatible with non-Ikelite strobes or non-digital Ikelite strobes.

This product is not compatible with non-digital Ikelite strobes, SEA&SEA, INON, or other non-Ikelite strobes.

The strobe's output may be adjusted using the manual power settings built into the strobe (varies by model). Make sure the camera’s flash mode is set to manual. Choose the minimum flash output necessary in the camera to trigger the DS strobe. This will conserve the camera’s battery power.

Camera and housing compatibility

Ikelite Housing Models with TT5 Canon TTL Transmitter #44701 installed.

Strobe compatibility

Ikelite D51
Ikelite DS125 above serial # 5000
Ikelite DS160, DS161, DS162
Ikelite DS200 above serial # 7163
Ikelite DS230, DS232